Figure 6-53 Registration Assembly (3 of 3) 6 Lift the registration guide and remove 2 screws at the front of the assembly (figure 6-53, callout 4). To Reinstall: 1 Lift the registration guide, and place the Registration Assembly into position. 2 Lift the registration guide and make sure that the locator pin near the right screw is properly positioned. 3 Make sure that the grounding strap is under the left screw. 4 Be sure to connect the clutch cable connector. 5 After replacing the 4 screws, replace the Main Gear Train Shield. Tilt the top outward, reinstall the lower tabs in place, and snap the cover down into position. C4085-91087 Engine Removal and Replacement 219