Latching Mechanism Figure 6-147 Latching Mechanism 1 Remove the 7-bin Tabletop Mailbox Handle (page 327). 2 Remove the E-clip in figure 6-147 (callout 1). 3 Move the bushing by sliding it over the shaft, to put it closer to the latching system (callout 2). 4 Slide the Latching Mechanism to the front of the device, and remove it. To Reinstall: Note Guide the pin through the hole. First slide the shaft into the hole located at the front bottom of the device. The tab on the bushing should be on the top during reinstallation. 328 Chapter 6 Removal and Replacement C4085-91087