Transport Belt Motor 1 Remove the Back Cover from the 8-bin Mailbox (see Figure 6-150). 2 Remove all the paper bins and the Blind Cover from the 8-bin Mailbox (see Figure 6-153). 3 Release the Controller PCA Assembly from the bottom of the 8- bin Mailbox frame (see figure 6-163 on page 346, steps 1 through 7). Figure 6-158 8-bin Mailbox Transport Belt Motor 4 Locate the cable that runs from the Transport Belt Motor to the 8- bin Mailbox Controller PCA, and disconnect the cable from the J8 connector on the Controller PCA (Figure 6-158, callout 1). 5 Remove the 2 screws (and washers) that secure the Transport Belt Motor to the 8-bin Mailbox frame (Figure 6-158, callout 2).
CAUTION When pulling out the motor, be careful to not damage the internal drive belt. 6 Gently pull out the motor. 340 Chapter 6 Removal and Replacement C4085-91087