Navigation Settings Select Settings > Navigation . Calculation Mode : Sets the route calculation method. Avoidances : Sets road features to avoid on a route. Custom Avoidances : Allows you to avoid specific roads or areas. Restricted Mode : Disables all functions that require significant operator attention. GPS Simulator : Stops the device from receiving a GPS signal, and saves battery power. Calculation Mode Settings Select Settings > Navigation > Calculation Mode . The route calculation is based on road speeds and vehicle acceleration data for a given route. Faster Time : Calculates routes that are faster to drive but can be longer in distance. Straight Line :
Calculates a direct line from your location to your destination. Setting a Simulated Location If you are indoors or not receiving satellite signals, you can use the GPS simulator to plan routes from a simulated location. 1 Select Settings > Navigation > GPS Simulator . 2 From the main menu, select View Map . 3 Tap the map twice to select an area. The address of the location appears at the bottom of the screen. 4 Select the location description. 5 Select Set Location . Driver Assistance Settings Select Settings > Driver Assistance . Driver Alerts : Allows you to enable or disable alerts for upcoming zones or road conditions ( Driver Awareness Features and Alerts , page 5 ). Speeding Alert :
Alerts you when you are exceeding the speed limit. Reduced Speed Tone : Alerts you when the speed limit decreases. Route Preview : Shows a preview of the major roads in your route when you start navigation. Proximity Alerts : Alerts you when you approach speed cameras or red light cameras. Proximity Alerts Settings NOTE: You must have custom points of interest (POIs) loaded for proximity points alerts to display. NOTE: This feature is not available in all areas. Select Settings > Driver Assistance > Proximity Alerts . Audio : Sets the style of alert that plays when you approach proximity points. Alerts : Sets the type of proximity points for which alerts are played. 24 Settings