Installation Procedure 1 Install the VVT solenoid coil (exhaust side) and tighten the two fixing bolts 1 of the VVT solenoid coil (exhaust side). Torque: 10N·m Caution Before installing the sensor, dip an oiling stick into an appropriate amount of engine oil and apply it evenly to the chamfer of the sensor mounting hole. 2 Connect the harness connector A of the VVT solenoid coil (exhaust side). KX11 PHEV 2023 Engine Engine control system (DHE15-ESZ) 2-37 3 Install the differential filter pressure sensor bracket and tighten the fixing bolts of the differential filter pressure sensor bracket. Torque: 10N·m 4 Install the differential filter pressure sensor.
5 Connect the negative cable of battery. 6 Use the GLDS diagnostic program. On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the