• Checking voltage. If there is a failure at this point, the Front Panel will display System Error Code 03:10 . For more information on troubleshooting this error code, refer to page 48. • Clear GPIO psu_lpm. If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. • Checking voltage. If there is a failure at this point, the Front Panel will display System Error Code 03:10 . For more information on troubleshooting this error code, refer to page 48. • Config GPIO drv_enable. If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 .
For more information on troubleshooting this error code, refer to page 47. • Starting Service Station. If there is a failure at this point, the Front Panel will display System Error Code 21:10 . For more information on troubleshooting this error code, refer to page 52. • Starting Scan Axis. If there is a failure at this point, the Front Panel will display System Error Code 42:10 . For more information on troubleshooting this error code, refer to page 60. • Starting Primer. If there is a failure at this point, the Front Panel will display System Error Code XX:XX . For more information on troubleshooting this error code, refer to page 60. • Homing Primer.
If there is a failure at this point, the Front Panel will display System Error Code XX:XX . For more information on troubleshooting this error code, refer to page 60. • Homing Service Station. If there is a failure at this point, the Front Panel will display System Error Code 21:10 . For more information on troubleshooting this error code, refer to page 52. • Homing Scan Axis. Tests and Utilities If there is a failure at this point, the Front Panel will display System Error Code XX:XX . For more information on troubleshooting this error code, refer to page 60. 3. Once the Primer has initialized a message will appear on the Front Panel asking which pen you want to prime.
Select the pen number (0 to 7) by using the Up and Down keys and press Enter to confirm your selection. If you select No , the printer skips this test and goes to the next one: 4. The Printer will prime the selected pen and the Front Panel will display the following messages: • Setting pens operational. • Preparing fluid manager. • Priming... • Terminating fluid manager. Entering the Service Tests Menu 123