Service Utilities The following is a list of all internal Service Utilities available in the Printers. Instructions for entering the Service Utilities menu are given on page 133. 1. Turn Drive Roller ⇒ page 134 The purpose of this Service Utility is to rotate the Drive Roller and the Overdrive in order to clean them. 2. Prime Tubes ⇒ page 135 The purpose of this Service Utility is to Prime the Tubes when the Ink Tubes are NOT new and they need to be re-primed or automatic priming was not completed correctly. 3. Set SN ⇒ page 138 The purpose of this Service Utility is to set the Serial Number of the Printer. 4.
Reset Life Counters ⇒ page 138 The purpose of this Service Utility is to reset the internal life counters. There are two submenus that allow you to: • Reset ALL the counters related to a Preventive Maintenance Kit (PMK). • Reset only the counters related to a specific replaced part. 5. Diagnostic Print ⇒ page 140 The purpose of this Service Utility is to print the Diagnostic Print in order to identify image quality problems. 6. Sleep Mode ⇒ page 141 The purpose of this Service Utility is to enable/disable the sleep mode so that the Printer is never switched Off automatically if not used for a certain period of time (one hour by default). 7.
Replace Cutter ⇒ page 142 The purpose of this Service Utility is to move the Carriage to a position where the Cutter can be replaced easily. 8. Set RTC Clock ⇒ page 142 Tests and Utilities The purpose of this Service Utility is to set the Real Time Clock (RTC) of the Printer. 9. Enable/Disable Firewall ⇒ page 143 The purpose of this Service Utility is to enable or disable the firewall of the printer. 10. Prime Pen X ⇒ page 144 The purpose of this Service Utility is to prime a specific pen. 11. Open/Close SOL ⇒ page 145 The purpose of this Service Utility is to open and close the Color Sensor shutter. 12.
Disk Wipe DoD 5330.22’M ⇒ page 145 The purpose of this Service Utility is to securely erase data on the Hard Disk. 13. Enable/Disable SCAPA The purpose of this Service Utility is to enable or disable the SCAPA. 14. Test the Color Sensor (Spectrophotometer) ⇒ page 145 This test checks that the Spectrophotometer is correctly cailbrating the color for the printer. 132 Chapter 4 Service Tests and Utilities