• Replace the Encoder Disc and Sensor ⇒ Page 417. System Error: 58:10 Problem Description: An error detected with the Color Sensor. Corrective Action: System Error Codes Try the following: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Printer has the latest firmware version. If not, update the Firmware to the latest version. • Perform the Color Sensor test. • If the error is displayed during the printer’s initilization, perform the Color Sensor Test from the diagnostic boot mode ⇒ page 119.
• If the error is displayed after the printer has initialized, for example when performing a Color Calibration/Linearization, perform the Spectrophotometer test ⇒ page 148. • If the Color Sensor Shutter opens and closes, then replace Color Sensor Assembly ⇒ Page 392 . • If the Color Sensor Shutter is not activated: • If the Color Sensor Actuator Lever does not elevate or is broken: 1. Replace the Color Sensor Actuator Assembly ⇒ Page 395. • If the SOL Actuator Lever elevates but does not always catch the shutter, clean the Encoder Strip using a lint free cloth with damp water ⇒ Page 454. 2. Clean the Encoder Strip using a lint free cloth with damp water ⇒ Page 454.
• If the System Error continues, replace the Carriage PCA ⇒ Page 334 . System Error: 61:01 Problem Description: The file format is incorrect and the Printer cannot process the job. Corrective Action: Try the following: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check the graphic language setting of the Printer (Refer to the User’s Guide). • Resend the file to the Printer. • Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest version. • If printing from a RIP check that the RIP version is the latest available. System Error:
61:04.1 68 Chapter 2 System Error Codes