H8DCE User's Manual 2-9 Floppy, IDE, Parallel Port and SATA Drive Connections Use the following information to connect the fl oppy and hard disk drive cables. The fl oppy disk drive cable has seven twisted wires. A red mark on a wire typically designates the location of pin 1. A single fl oppy disk drive ribbon cable has 34 wires and two connectors to provide for two fl oppy disk drives. The connector with twisted wires always connects to drive A, and the connector that does not have twisted wires always connects to drive B. The 80-wire ATA133 IDE hard disk drive cable that came with your system has two connectors to support two drives.
This special cable should be used to take advantage of the speed this new technology offers. The blue connector connects to the onboard IDE connector interface and the other connector(s) to your hard drive(s). Consult the documentation that came with your disk drive for details on actual jumper locations and settings for the hard disk drive. Floppy Connector The fl oppy connector is located beside the IDE#1 connector. See the table on the right for pin defi nitions.
2-20 Floppy Drive Connector Pin Defi nitions (JFDD1) Pin# Defi nition Pin # Defi nition 1 GND 2 FDHDIN 3 GND 4 Reserved 5 Key 6 FDEDIN 7 GND 8 Index- 9 GND 10 Motor Enable 11 GND 12 Drive Select B- 13 GND 14 Drive Select A- 15 GND 16 Motor Enable 17 GND 18 DIR- 19 GND 20 STEP- 21 GND 22 Write Data- 23 GND 24 Write Gate- 25 GND 26 Track 00- 27 GND 28 Write Protect- 29 GND 30 Read Data- 31 GND 32 Side 1 Select- 33 GND 34 Diskette