Hantek 6000EU Digital Oscilloscope Set Channel Coupling Click “Coupling ” in “Vertical Setup ” window In the sidebar, you can change the channel coupling too . You can set the coupling to DC , AC or GND . If you set the coupling to DC , it blocks the AC component of the input signal. Probe Attenuation Setting Select the attenuation factor for the probe. To check the probe attenuation setting, toggle the probe menu to match the attenuation factor of the probe. This setting remains in effect before you changed again. Click “Probe ” in Vertical Setup window to select the probe attenuation The probe setting window in the sidebar Note :
The attenuation factor changes the vertical scale of the oscilloscope so that the measurement results refect the actual voltage levels at the probe tip. USER’S MANUAL 29