Removal and Installation Electronics Module (as one complete Assembly) Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Left Rear Cover - Refer to Page 8-15 . 2. Remove the Right Rear Cover - Refer to Page 8-16 . 3. Disconnect ALL Cables from the Main PCA (Right Rear Cover) and ISS PCA (Left Rear Cover) and remove the Ferrites from the left side. Remove 2 T-15 screws ( Type B ) from the both sides of the Electronics 5. Lift the Electronics Module up (to clear it from the shoulder screws) and remove from the Printer.
1 2 1 8-97 HP DesignJet 5000 and 5500 Series Printers Service Manual LEFT RIGHT 4. Rem the b Mod