Removal and Installation Pinch-Wheels Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Top Cover - Refer to Page 8-5 . 2. Remove the Back Cover - Refer to Page 8-23 . 3. Remove the Electronics Module - Refer to Page 8-97 . 4. Remove EMC Covers as one assembly - Refer to Page 8-32 . NOTE For the next steps place the Media Lever in the UP position. 5. Remove the following T-20 screws ( Type Q ): For the 60" Model remove 4 screws from each group of 4 Pinch-Wheels (5 groups in total).
For the 42" Model remove 4 screws from each group of 4 Pinch-Wheels (3 groups in total) and 2 screws from the one group with 2 Pinch- Wheels. 8-98 HP DesignJet 5000 and 5500 Series Printers Service Manual