LaserJet I/ID (26860) This can be connected directly to the HP3000 as the serial I/O has status feedback. Configuration is acheived via a bank of switches which are accessed by removing the rear panel (4 scrws). Switch setting are: K . ConfigurinpHP LaserJets on HP3000 When configuring the Laserjets on the 3000 use TerrnType 22@CL22 or TermType 26/ PCL26. The2686, 2684 and33440have Statusfeedbackfb.uction@ andcanbecotdigared dire~. The LaserJets mantiactured fiertkeseproducts require an Optional J/O bosrdto be inst~ed. More dti for spectic Laserjets is listed below ,!$.>-,.*,>.? :~,f,*;:* 1 -OFF(Serial) ,,.,,, ,.:; ,*$ ;y. x$ :V$#$~ .> *# ,: ,?
,“$/j,,,, 2 ?~ -X Baud rate selection ,~;, ~~~ 7:;~ .,.*,. ,., ~$,*. & 3 -X Baud rate selection 300 Om OFF OFF 4 -X Baud rate selection 600 OFF OFF ON 6 -ON (L3i+ ordy, enables 1200 OFF ON OFF ROBUSTXon) 2400 OFF ON ON 8 -ON(DTRpolarityset Hi) 4800 ON OFF OFF 9600 ON OFF ON 19200 ON ON OW Note: Thestandard2686A First modelproduce~ has on@a sm”alI/O. ~e 2686A+ and the 2686D was ntanuf~tired with both Serial and Parallel I/Os. Note: See Cabling at the end of this 3000 con$~ation section. LaserJet II (33440\ Thisptiter ~ has status feedback built into the the I/O and can be directly connected to the HP3000.
This configuration settings is acheivedtia the operators front psneL Typical settings are SYMBOL SET = Roman-8 J/o = s= BAUDRA~ =9600 (Defati) ROBUSTXon = ON DTRPO~ ‘m Note see Cabling at the end of this 3000 con~guration section. LaserJet III (33449): IID (3344n: DID {33459) These LaserJetshasno statnsfeedbac~therefore cannot beconnectedtothe HP3000, exceptvia dummyTenuT~e 18.To connecttotheHP3000 anoptional I/Oboard (260 13A) is required to be installed iu the optional I/O port at the rear of the priuter. This board is no longer available, but ESJ/ExcelJink may ofir an alternative (see HP tierJet Ref@ence Guide (Green book), page section 7). Set, via front pane~ I/Oto OPTIONAL. 1-14