more detailed on the following pages. START Intstall and wire the drive as explained. Turn the power on. Initialize the drive if necessary using parameter A1-01. Set the control mode. Perform Auto-Tuning or set the motor data manually. Set/check the basic parameters: * b1-01, b1-02 for frequency reference and RUN command source * H1-xx, H2-xx, H3-xx, H4-xx, H6-xx to configure the I/Os * Frequency reference values * C1-xx, C2-xx for Acceleration/Deceleration times and S-curves Run the motor without load, check the operation and verify, if the upper controller (e.g. PLC,...) commands to the drive work as desired.
Connect the load, run the motor and check the operation Fine tune and set application parameters (e.g. PID,...) if necessary. Final check the operation and verify the settings. Drive is ready to run the application I67E-EN V1000 Quick Start Guide 17 SH 5 Start Up GLI Drive Setup Procedure EN