Licensing Installing a New Softkey License Note: These instructions only apply to installing a softkey license for InduSoft Web Studio. To install a license for CEView, see Installing or Upgrading a CEView License (Locally) on page 46 or Installing or Upgrading a CEView License (Remotely) on page 49. Also, you must have Administrator privileges on the computer on which you are installing or modifying a softkey license. To install a new softkey license for InduSoft Web Studio: 1. Install InduSoft Web Studio according to the instructions provided earlier in this chapter. 2. Launch the Protection Manager by choosing Start > All Programs > InduSoft Web Studio v7.0 > Register . 3.
Select Softkey in the Protection Type group, and then click Check . Protection Manager: Softkey Note: If you already have a hardkey license installed on your computer, then you will be asked to confirm the change of protection type. The Softkey Settings dialog displays: • If you already have a valid InduSoft Web Studio softkey license installed, then the current license settings display. • If you have not previously installed a license on your computer, then the Status text box displays a "License not found" message. 4. Click the Change License button on the Softkey Settings dialog. Checking the Softkey Settings 5.
When the Change License – Softkey dialog displays, copy the code information from the Site Code text box and send it to your software vendor. Change License: Softkey Your software vendor will send back a Site Key that matches this Site Code. Type the Site Key into the Site Key field of the Change License – Softkey dialog and then click the Authorize button. InduSoft Web Studio Page 43