en Cookware test 5. Select the required setting in the settings area. 6. Touch and hold for 4 seconds. a This saves the settings. 17.3 Discarding changes to the basic settings ▶ Touch . a All changes are discarded and not saved. Cookware test 18 Cookware test The quality of the cookware has a major influence on the speed and the result of the cooking process. You can use this function to test the quality of the cook- ware. Before the test, ensure that the diameter of the cook- ware base corresponds to the diameter of the cooking zone being used. Access is via the basic settings. → Page 13 a After 10 seconds, the result appears in the cooking zone displays.
18.2 Checking the result You can see what the result means for the quality and speed of the cooking process in the following table. Result 18.1 Carrying out Cookware test The cookware is not suitable for the cooking zone and therefore does not heat up. The cookware is taking longer to heat up than ex- pected and cooking is not progressing as well as it ought to. The cookware is heating up correctly and cooking is progressing well. 1. At room temperature, place the cookware with ap- prox. 200 ml water in the centre of the cooking zone that best fits the base of the cookware in terms of size. 2. Call up the basic settings and select . 3. Touch the settings area.
flashes in the cooking zones. a The function is switched on. Note: If you have any unfavourable results, reposition the cookware on a smaller cooking zone, if available. To reactivate this function, touch the settings area. Home Connect 19 Home Connect This appliance is network-capable. Connecting your ap- pliance to a mobile device lets you control its functions via the Home Connect app, adjust its basic settings and monitor its operating status. The Home Connect services are not available in every country. The availability of the Home Connect function depends on the availability of Home Connect services in your country. You can find information about this at: www.home-connect.com.
19.1 Setting up the Home Connect app 1. Install the Home Connect app on your mobile device. 2. Start the Home Connect app and set up access for Home Connect. The Home Connect app guides you through the en- tire login process. The Home Connect app guides you through the entire login process. Follow the instructions in the Home Con- nect app to configure the settings. Tip: Please also follow the instructions in the Home Connect app. Notes Ў Please note the safety precautions in this instruction manual and make sure that they are also observed when operating the appliance via the Home Con- nect app. → "Safety", Page 2 Ў Operating the appliance on the appliance itself al- ways takes priority.
During this time it is not possible to operate the appliance using the Home Connect app. Ў In networked standby mode, the appliance requires a maximum of 2 W. Ў Hobs are not designed to be left unattended. Al- ways monitor the cooking process. 19.2 Setting up Home Connect Requirements Ў The appliance is connected to the power supply and is switched on. Ў You have a mobile device with a current version of the iOS or Android operating system, e.g. a smart- phone. Ў The Home Connect app has been installed on your mobile device. Ў The appliance is receiving signals from the WLAN home network (Wi-Fi) at its installation location.
Ў The mobile device and the appliance are within range of your home network's Wi-Fi signal. 1. Open the Home Connect app and scan the follow- ing QR code. 14