ISPSoft User Manual Example: Ex1 : Download test.dup to PLC.AS332T and run PLC with the default value of communication setting (9600, 7, e, 1). File directory under the current path: "PLC CARD.exe" /PLC=AS332T /F=test.dup /RUN /C=1 File directory under the appointed path: "d:\temp\PLC CARD.exe" /PLC=AS332T /F=d:\temp\test.dup /RUN /C=1 Ex2 : Stop PLC AS324MT via Ethernet. "PLC CARD.exe” /PLC=AS324MT /Stop /IP=192.168.1.1 Return Codes and Corresponding Messages 21-18 Commands Parameters Functions (Set 0 mean no limits to the number of retries) command after the download is complete. E.g./Lock=1234, 0 (Note:
If there’s a password in DUP file, it would be automatically set as the password for PLC after the download is complete.) /UnLock=P1 P1=password If the PLC has been secured by password lock and a same password does not exist in the DUP file, users must remove PLC password before downloading. E.g./Unlock=1234 (Note: Users can set password again by using /Lock command or downloading a DUP file which includes a password.) /P=P1, P2, P3, P4 P1=Baud Rate P2=Data Bits P3=Parity P4=Stop Bits Set the communication protocol. The default value is 9600, 7, e, 1. Leave blank for values remain unchanged, while “,” is necessary to be input. ex1:Change all the setting values.
/p=115200, 8, n, 2 ex2:Only change the Baud Rate. /p=115200, , , Must input “, ”. /Save=P1 P1=File name Assign the path and the file name to save returned codes. If a specified path directory does not exist, it will be generated automatically. A default file name “Result.txt” will be taken as the current path when this command is not used or the parameter is empty. Ex:/Save=C:\test\result1.txt Please find the return codes table below for the corresponding messages. /IP=P1 P1=IP address Assign Ethernet IP address. When this command is used, it means to communicate via Ethernet, which cannot be used with /C command. Ex: /IP=192.168.1.5 Code Message 1 Finish! 2 Timeout!
3 The PLC type does not match! 4 DUP File is error! 5 Communication port has been used or no this port! 6 Cannot open file 7 Command is incorrect! 8 Command H is incorrect! 9 Command P is incorrect! 10 Reserved. 11 COM port number is incorrect! 12 Command R is incorrect!