Delta ISPSoft — 23.1.3 Positioning Table Simulation

Chapter 23 Wizard Tool By clicking 2-axis arc interpolation in the list section, then click 2-axis simulation mode (see below), both 2-axis linear interpolation and arc interpolation are shown on the same simulation graph with a mixture image of both continuous paths. By clicking Single-axis point-to-point motion page, then click single axis simulation mode , the single-axis point-to-point and multi-segment simulation graphs only shows the same mode path. Also, right-click on an empty spot in the single simulation graph window and a pop-up list appears for switching the scroll wheel direction (see below).

For Target Simulation functions, users need to declare symbols in DWORD or DINT type in global symbols. Then, select either Absolute (Symbol/Address) or Relative (Symbol/Address) for ABS/REL mode in edit section, and type in symbol or device for Objective position (see below). that D100 is estimated to occupy the length of D100 and D101. For Objective position in the position planning table, the smallest unit is DWORD. So, please be aware 23-7