ISPSoft User Manual A.2 Create USB Driver in COMMGR The steps of creating a driver whose connection type is USB in COMMGR are as follows. (1) Make sure that the PLC is supplied with power normally. Connect the PLC to a USB port on the computer with a USB cable. (2) Make sure that COMMGR is started, and the icon representing COMMGR is displayed on the system tray. If the icon representing COMMGR is not displayed on the system tray, users can start COMMGR by clicking the shortcut on the Start menu ( Start > Programs > Delta Industrial Automation > Communication > COMMGR) . (3) Double-click the icon representing COMMGR on the system tray, and then click Add in the COMMGR window.
(4) Type a driver name in the Driver Name box, and then select USB (Virtual COM) in the Type drop-down list box in the Connection Setup section. If the PLC connected is a DVP-SX2 series PLC, RS232 in the Type drop-down list box must be selected. Please refer to the following section for more information. (5) Select a device name which corresponds to the PLC connected in the COM Port drop-down list box in A-18