ISPSoft User Manual parameters in the modules which are uploaded are the same as the hardware configuration and the parameters in the modules which were previously downloaded to the CPU module. In other words, after Upload is clicked, the system parameters in the CPU module will read, and the actual hardware configuration will not be uploaded. Next, I/O Scan is clicked, and the scan result is downloaded to the CPU module. The BUS FAULT LED indicator on the CPU module will be OFF, that is to say, the hardware configuration in the CPU module is the same as the actual hardware configuration.
3.8.6 AH Series Online Diagnosis Users not only can configure modules in HWCONFIG offline, but also can operate and inspect the system through the Online Mode function if ISPSoft is connected to the CPU module. Owing to the fact that HWCONFIG adopts the communication setting in ISPSoft, users have to make sure that ISPSoft is connected to the CPU module normally before the Online Mode function is enabled.
If users want to enable the Online Mode function, but the name of the CPU module is different from the name attached to the model in the project management area, the system will remind the users to check the name of the CPU module and the name attached to the model in the project management area. 3.8.6.1 Online Mode (1) After users click Online Mode on the Option menu, or on the toolbar, the hardware configuration will be in the online mode. If the users click again, the hardware configuration will not be in the online mode. 3-248