ISPSoft User Manual If users want to write the program shown in section 5.6.1 again, they have to refer to chapter 4 and section 5.6.1, and complete the hardware configuration, the parameter setting, and the task management. After the writing of the program is complete, the users have to compile the program, and download the parameters and the program to the CPU module. Before the program is downloaded to the CPU module, the users have to select the Initial Value checkbox in the Transfer Setup window. Once the Initial Value checkbox in the Transfer Setup window is selected, the initial value of CNT_DT in COUNTING will be written into the CPU module. 6-48