Chapter 2 Starting and Setting ISPSoft (4) In the IP Address Setting , setup the communication device IP address and name. Click Search and the result for devices in the same network are shown in the box. Click Add for a new IP address and input information regarding each cell. IP address: The device IP address. Port: Used during communication, default setting is 502. Label: The name of the device. Type: The device model type that can be found through clicking Search . Select an IP address and click Del or press Delete on the keyboard to remove it from the list. (5) To setup parameters concerning responding time.
For Connect Retries, users need to setup the number of retry once connection error occurs, while for Connection Time-Out setting, the parameter concerns the time interval between retries. *. When changing an internet device connected to a PC, users need to close the setting page concerning communication driver properties and re-start in order to obtain the new internet device. 2.4.3.5 Communication Parameter Setting - DirectLink (Ethernet) (1) Type the Driver Name . To add special marks, only ‘_’ can be used. (2) For Connection Setup , select DirectLink (Ethernet) from the drop-down list for Type . (3) For Ethernet Card , select the desired network card from the drop-down list.
The current IP address is shown below the description. (4) In the IP Address Setting , setup the communication device IP address and name. Click Search and the result for devices in the same network are shown in the box. 2-49