D.2 European Standards D.2 European Standards Figure D.1 CE Mark The CE mark indicates compliance with European safety and environmental regulations and is required for engaging in business and commerce in Europe. European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive for electronics manufacturers and the EMC guidelines for controlling noise. This drive displays the CE mark based on the EMC guidelines and the Low Voltage Directive. • EMC Guidelines: 2004/108/EC • Low Voltage Directive:
2006/95/EC u CE Low Voltage Directive Compliance This drive has been tested according to IEC61800-5-1:2007, and it fully complies with the Low Voltage Directive. To comply with the Low Voltage Directive, be sure to meet the following conditions when combining this drive with other devices: n Area of Use Do not use drives in areas with pollution higher than severity 2 and overvoltage category 3 in accordance with IEC664. n Installing Fuses on the Input Side Always install input fuses. Select fuses according to Table D.1 . Table D.1 Recommended Input Fuse Selection n Grounding The drive is designed to be used in T-N (grounded neutral point) networks.
If installing the drive in other types of grounded systems, contact your dealer for instructions. u EMC Guidelines Compliance This drive is tested according to IEC61800-3:2004 and it complies with the EMC guidelines. 212 SIEP C710606 33A OYMC AC Drive – J1000 User Manual Drive Model JZA Class T Fuses Model Fuse Ampere Rating 200 V Class Single-Phase Drives B0P1 A6T15 15 B0P2 A6T20 20 B0P4 A6T20 20 B0P7 A6T40 40 B1P5 A6T40 40 200 V Class Three-Phase Drives 20P1 A6T10 10 20P2 A6T10 10 20P4 A6T15 15 20P7 A6T20 20 21P5 A6T25 25 22P2 A6T30 30 24P0 A6T40 40 400 V Class Three-Phase Drives 40P2 A6T10 10 40P4 A6T10 10 40P7 A6T20 20 41P5 A6T25 25 42P2 A6T25 25 43P0 A6T25 25 44P0 A6T30 30