Adjusting Input Trays for Normal Printing This procedure applies to Trays 2 and 3 (the standard paper trays in the printer) and Trays 4 and 5 in the 2 x 500-sheet Input Tray. To adjust the 2000-sheet Input Tray see “Adjusting the 2000-sheet Printer Input Tray” on page 172. The paper trays are mechanically aligned to the printer chassis at the factory. Perform this procedure ONLY if a paper tray has been replaced with a tray other than the original factory installed tray, or if the top margin of the image area is off-center more than 0.5 mm (0.02 inch). The adjustment procedure is identical for Trays 2, 3, 4, and 5 from the 2 x 500-sheet Input Tray.
Note Before performing this procedure, check that the margins in your software application are properly set. 1 Load the paper tray being tested with letter or A4 size paper. 2 Perform a 1-sheet Paper Path Test from that tray (see Paper Path Test under Test Menu in Chapter 3). 3 See figure 4-3 and compare distance A to distance B. Figure 4-3 Image Area Margins 170 Chapter 4 Maintenance and Adjustments C4265-90907