QuickStart 3.7 Commissioning and diagnostic with KS2000 3.7.1 Which firmware support's the new KS2000 features Bus Coupler / Bus Terminal Controller NOTICE The Commissioning Mode requires certain firmware versions on the Bus Coupler or the Bus Terminal Controller. The firmware version is specified at the rear of the Bus Coupler (see example below for CANopen). If required, the firmware can be updated via the serial port (KS2000 cable required) or - depending on the bus system - via the fieldbus. The current firmware versions and the program for the firmware update can be found on www.beckhoff.com .
Not listed Bus Coupler and Bus Terminal Controller are not prepared for the Commissioning Mode. Fieldbus Box NOTICE The Commissioning Mode requires certain firmware versions on the Fieldbus Box. The firmware version is specified at the side of the Fieldbus Box. If required, the firmware can be updated via the serial port (KS2000 cable required) or - depending on the bus system - via the fieldbus. The current firmware versions and the program for the firmware update can be found on our home page at www.beckhoff.com . KS2000 33 Version:
6.2.0 Fieldbus System Bus Coupler / Bus Terminal Controller Firmware version required on the Bus Cou- pler / Bus Terminal Controller for the Com- missioning Mode Lightbus BK2020 in preparation (B1) Profibus BK3000 not supported BK3010 BA BK3100 not supported BK3110, BK3120 BA BK3150 in preparation (B0) BK3500, BK3520 BA LC3100 BA BC3100 in preparation (C4) BX3100 in preparation (1.00) Interbus BK4020 not supported BC4000 not supported CANopen BK5120 B0 BX5100 in preparation (1.00) DeviceNet BK5220 in preparation ControlNet BK7000 BB Modbus BK7300 in preparation (B4) Sercos BK7500, BK7520 not supported Fip IO BK7420 B1 RS485 BK8000 not supported RS232 BK8100 not supported Ethernet BK9000 in preparation (B9) BC9000 in preparation (BA) USB BK9500 not supported CX CX1100 in preparation (B4)