L-6534VW Operation Guide Basic Operations C Make settings for performing reverse feed the substrate in the preset for reverse feeding, and set it as the default preset. See the following pages for more information on creating presets. U “Creating and Editing Preset for Reverse Feeding” on page 95 D Perform printing from the print software, and then check that the print data with ruled lines was received on the touch panel. E Select the print job from the Job Management menu, and then press Print Settings . F Set the following, and then press OK . G Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing.
Print the first copy, and then the press automatically adjusts the sensor sensitivity. H If the first copy pauses on the unwinder side workbench, press Print to Fine-tune . Print the second copy, and then pause on the unwinder side workbench. I Check the print results, and measure the gaps between ruled lines in the first and second copy using a loupe with a 0.05 mm scale. 147 Item Set value Reverse Feeding Apply Eye Mark for Reverse Feeding Use Distance from Top Edge of Substrate Apply to print data Distance from Right Edge of Print Job Apply to print data Reverse Feeding Position Adjustment 2 mm Item Set value Copies 1 Perform Eye Mark Verification Printing Select