L-6534VW Operation Guide Various Print Settings F Press Start feed . The substrate is fed reversely to the unwinder side by the amount entered for Feeding Amount . G You are returned to the Operation Status screen, perform daily maintenance, and then turn off the press. This completes this section. Operations when starting work differ between normal printing and additional printing. If you normally print the next day, see the following. U “When starting (normal printing)” on page 207 If you perform additional printing the next day, see the following.
U “When starting (additional printing)” on page 210 When starting (normal printing) This section explains the procedure of starting work in normal printing. A Startup the press and perform the startup inspection. B Check that the press switch is set to the Standby position. C Press Substrate Settings on the menu on the left, and then on the Feed Subst tab, set Feeding Amount to "33 m" (at a print speed of 30 m/min). Feed the substrate by the amount you wound it to the unwinder side the previous day. The input value for Feeding Amount varies depending on the selected print speed. 207