1.3 to 1.7 (13.3 to 17.3 kgf*cm, 11.5 to 15.0 in.*lbf) (d) Remove the RH and LH rack ends. gn 12. INSTALL CLAW WASHER AND RACK END (a) Install a new washer, and temporarily tighten the rack end. HINT: Align the claws of the washer with the steering rack grooves. (b) Using a spanner to hold the steering rack steady, and using SST, torque the rack end. SST: 09922-10010 Torque: 99 N·m {1,014 kgf·cm, 74ft·lbf} NOTICE: Use SST 09922-10010 in the direction shown in the illustration. HINT: Use a torque wrench with a fulcrum length of 380 mm (13.58 in.). (c) Using a brass bar and hammer, stake the washer. NOTICE: Avoid any impact to the rack.
(d) Use the same procedure described above for the other side. 13. INSTALL RACK BOOT, CLAMP AND CLIP (a) Ensure that the tube hole is not clogged with grease. HINT: If the tube hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned. (b) Install the boot. NOTICE: Be careful not to damage or twist the boot. (c) Using pliers, tighten a new clamp, as shown in the illustration. (d) Use the same procedure described above for the other side. cardia