gn 6. ADJUST TOE-IN (a) Check or adjust the lengths of the rack ends, then adjust the toe-in. Standard rack end length difference: 3.0 mm (0.118 in.) or less (b) Remove the boot clamps. (c) Loosen the tie rod end lock nut. (d) Turn the right and left rack ends by an equal amount to adjust the toe-in. HINT: Try to adjust the toe-in to the center of the specified value. (e) Tighten the tie rod end lock nuts. Torque: 55 N·m {560 kgf·cm, 41ft·lbf} (f) Place the boots on the seats and install the clamps. HINT: Make sure that the boots are not twisted. (g) Perform the VGRS system calibration . (h) Perform the 0 point calibration of the yaw rate and deceleration sensor . 7.
INSPECT AND ADJUST WHEEL ANGLE (a) Turn the steering wheel fully to the right and left, and measure the turning angle. Standard wheel turning angle: cardia