Команда show vlan отображает параметры для всех сетей VLAN, настроенных в административном домене.
CatosSwitch> (enable) show vlan VLAN Name Status IfIndex Mod/Ports, Vlans ---- -------------------------------- --------- ------- ------------------------ 1 default active 5 1/1-2 3/1-48 4/1-16 1002 fddi-default active 6 1003 token-ring-default active 9 1004 fddinet-default active 7 1005 trnet-default active 8 VLAN Type SAID MTU Parent RingNo BrdgNo Stp BrdgMode Trans1 Trans2 ---- ----- ---------- ----- ------ ------ ------ ---- -------- ------ ------ 1 enet 100001 1500 - - - - - 0 0 1002 fddi 101002 1500 - - - - - 0 0 1003 trcrf 101003 1500 - - - - - 0 0 1004 fdnet 101004 1500 - - - - - 0 0 1005 trbrf 101005 1500 - - - ibm - 0 0 VLAN DynCreated RSPAN ---- ---------- -------- 1 static disabled 1002 static disabled 1003 static disabled 1004 static disabled 1005 static disabled VLAN AREHops STEHops Backup CRF 1q VLAN ---- ------- ------- ---------- ------- 1003 7 7 off Чтобы создать сети VLAN, воспользуйтесь командой set vlan .
1. CatosSwitch> (enable) set vlan Usage: set vlan (An example of mod/port is 1/1,2/1-12,3/1-2,4/1-12) set vlan [name ] [type ] [state ] [pvlan-type ] [said ] [mtu ] [ring ] [decring ] [bridge ] [parent ] [mode ] [stp ] [translation ] [backupcrf ] [aremaxhop ] [stemaxhop ] [rspan] (name = 1..32 characters, state = (active, suspend) type = (ethernet, fddi, fddinet, trcrf, trbrf) said = 1..4294967294, mtu = 576..18190 pvlan-type = (primary,isolated,community,none) hex_ring_number = 0x1..0xfff, decimal_ring_number = 1..4095 bridge_number = 0x1..0xf, parent = 2..1005, mode = (srt, srb) stp = (ieee, IBM, auto), translation = 1..1005 hopcount = 1..13) Set vlan commands:
---------------------------------------------------------------------------- set vlan Set vlan information set vlan mapping Map an 802.1q vlan to an Ethernet vlan CatosSwitch> (enable) set vlan 2 name cisco_vlan_2 Vlan 2 configuration successful Чтобы проверить конфигурацию сети VLAN, воспользуйтесь командой show vlan . 2. CatosSwitch> (enable) show vlan VLAN Name Status IfIndex Mod/Ports, Vlans ---- -------------------------------- --------- ------- -------------------- 1 default active 5 1/1-2