8. TURBOCHARGER 8.4 Disassembly Procedure 8.4.1 Preparation for disassembly In addition to the general tools, the following special tools are required for turbocharger disassembly and reas- sembly: 8-10 82E-5 – 98E-5 SERIES Tool name Use Illustration Bar For removing thrust bearing and thrust bushing Material: Copper or brass Pliers For removing floating bearing circlip Pliers For removing seal ring Torque driver for TORX bolt (multifunctional type) 0.5 to 4.9 Nm {5 to 50 kgm} For thrust bearing installation (for M3): 1.3 Nm {13 kgm} For seal plate installation (for M3): 1.3 Nm {13 kgm} Item sold on market (Type:
TORX TT20 or equivalent) Box wrench For fixing turbine shaft (10 mm x 12 square) Box only may be used. Torque wrench (single purpose) For following bolts and nuts: M8: mm, kgm {Nm} M5: mm, kgm {Nm} M5: mm, kgm {Nm} Probe For measuring play in axial and radial directions: To be installed on a dial gauge