9. STARTING MOTOR (4) Brush holder (a) Brush holder insulation test Check the continuity between the brush holder (+ side) and base (– side) with a mul- timeter. Good if no continuity exists. If continuity exists (insulation defect), replace the brush holder. (b) Brush spring inspection Inspect the brush spring pressure. N {kg} Standard spring force 31 – 39 {3.1 – 3.9} (5) Magnetic switch When the starting motor is wetted with water, always replace the magnetic switch with a new even if the function is normal. (a) Shunt coil continuity test Check the continuity between the S terminal and the switch body. Good if continuity exists.
If no continuity (coil disconnection), replace the magnetic switch. 9-12 82E-5 – 98E-5 SERIES