9. STARTING MOTOR (3) Pinion projection length Connect the positive (+) lead from the battery to terminal S and negative (–) lead to terminal M . Turn the switch ON and measure the pinion moving distance l in the thrust direction. Perform this test within 10 seconds. mm Note: Before measuring the dimension, pull the pinion out lightly in the direction of the arrow. If the measured l dimension is outside the stan- dard range, either insert or remove the dust cover (adjusting shim 0.5 mm, 0.8 mm) for adjustment. 9-16 82E-5 – 98E-5 SERIES Standard l 0.3 – 1.5