Pausing Adding Water or Cleaning Mop Pad During Cleaning Press any buton to pause the vacuum-mop during cleaning. To resume cleaning, press the buton . Press the buton to end the current cleaning task and the vacuum-mop will go back to the charging dock. If you need to add more water to the vacuum-mop or clean the mop pad during a cleaning task, press any buton to pause the vacuum-mop, then remove the mopping module. Afer adding water or cleaning the mop pad, reatach the mopping module, then press the buton to resume the cleaning task. Note: When the vacuum-mop is paused, placing it onto the charging dock will end the current cleaning task.
If you need to continue cleaning, try to start the vacuum-mop in the same position where it was paused. Fault Status Cleaning Methods If the vacuum-mop encounters an error during operation, the power indicator will blink orange and you will hear a voice alert. To check for a solution, please refer to "Troubleshooting". Upon activation, the vacuum-mop will methodically clean each room in an S-shape patern, then finish by cleaning along edges and walls to ensure a thorough job. When the vacuum-mop is done cleaning, it will automatically return to the charging dock to recharge. Note:
The vacuum-mop will automatically enter sleep mode afer encountering an error if no action is taken within 10 minutes. If the vacuum-mop has an error, placing it onto the charging dock will end the current cleaning task. Sleep Mode When the vacuum-mop is in standby mode or paused, press and hold the buton for 3 seconds to start Spot Clean mode. In this mode, it will clean a square-shaped area of 1.5 Ч1.5 meters directly around the vacuum-mop. When the spot cleaning is done, the vacuum-mop will automatically return to its original location and shut off. 1.5m The vacuum-mop will automatically enter sleep mode afer 10 minutes of inactivity, then the power and charging indicators will go off.
To wake up the vacuum-mop, press any buton. 1.5m Note: The vacuum-mop will not enter sleep mode until it is fully charged. Note: Activating Spot Clean mode will end the current cleaning task of the vacuum-mop. 10