Expanding the OmniBook Installing a Hard Disk Drive To replace the hard disk drive holder If you are installing a new hard drive that does not have a plastic holder, you can remove the holder from the old hard drive. You’ll need a small Phillips screwdriver for this procedure. 1. Remove the four screws from the sides of the case. 2. Remove the top shield (if present) and swing out the free end of the hard drive about 90°, then gently pry off the connector from the hard drive. C A U T I O N Work the connector off the hard drive evenly, without pulling on the flex cable. Otherwise you may bend connector pins or the hard drive or damage the flex cable.
Note Depending on the form factor of the replacement drive, the following hard disk drive variations may exist: • The hole placement for the four screws may vary. • The hard drive may have either a one– or two–piece shield. • If your original drive was a 9.5mm and you are replacing it with a 12.7mm, remove the rubber spacers from the upper half of the hard disk drive shield before installing the new drive. 5-4