inserting the DIMM into the slot Replace the cover and gently apply pressure until the cover snaps into place. Make sure the steel enclosure of the DIMM cover does not interfere with the DIMM slot locks. Reattach the cables and power cord. Turn on the printer and test the DIMM. test After installing additional printer memory, test the memory installation. Ensure that READY appears on the LCD control panel when the printer is turned on. If an error message appears, the DIMM may be incorrectly installed . Print a Configuration page. Compare the memory section of the Configuration page with the Configuration page printed before the DIMM installation.
If the amount of memory has not increased, perform the following checks: • The DIMM might not be installed correctly. Reinstall the DIMM. • The DIMM might be defective. Use a different DIMM. setup & configure hp restricted 2-21