2. While keeping a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (Fig. 5). Carefully close the window behind the top rail of the unit. Measure from the cabinet edge H H:About 5/8 ” to 3/4 for 5K) INSIDE 3 H:About 1” to 1 / for 10K to 12K) H:About 3/4” to 1” for 6K to 8K) OUTSIDE NOTE Wooden Windows Measure from the cabinet edge Check that air conditioner is tilted back per di m ension H (Fig. 5) (tilted about 3° to 4° downward to the outside). After proper installation, condensate should not drain fro m the overflow drain hole during nor m al use. Adjust the slope if otherwise.
H INSIDE H:About 3/4” to 1” for 5K to 8K) Installation Instructions OUTSIDE 3 H:About 1” to 1 / for 10K to 12K) Vinyl-Clad Windows Fig. 5 Fig. 6 3. Extend the side panels out against the window frame (Fig. 6). window fra m e 4. INSTALL SUPPORT BRACKET A. Place the frame lock between the frame extensions and the window sill as shown (Fig. 7A for Wooden windows), (Fig. 7B for Vinyl-Clad windows). Drive 3/4” (19 mm) or 1/2” (12.7 mm) locking screws through the frame lock and into the sill. Fig. 7A Fig. 7B NOTE: To prevent window sill from splitting, drill 1/8” (3 mm) pilot holes before driving screws. Fig. 8A B1: For wooden windows:
Drive 1/2” (12.7 mm) locking screws through the frame lock and into the sill (Fig. 8A). NOTE: To prevent window sill from splitting, drill 1/8” (3mm) pilot holes before driving screws. Drive 1/2” (12.7mm) locking screws through frame holes into window sash (Fig. 8B/8C). Page 22