3 . Preassemble a 4 inches ( 10.2cm ) elbow to the next 4 inches ( 10.2cm ) duct section, and secure all joints with aluminum tape. Be sure that the male end of the elbow faces AWAY from the dryer. Insert the elbow/duct assembly through the side opening and attach it onto the adapter duct. Secure in place with aluminum tape. Be sure that the male end of the duct protrudes 1.5 inches ( 3.8cm ) to connect the remaining ductwork . Attach aluminum to the back of the dryer. tape Dryer Safety Operation Requirements Parts and Features aluminum Tape (3.8 cm) Installation Instructions Dryer Use Appendix Dryer Care Troubleshooting Option 2: Bottom venting 2 .
Press the tabs on the knockout and carefully remove the knockout for the desired ventopening. Attach the adapter duct onto the blower housing of the dryer as shown . 3. Insert the 4 inches (10.2cm) elbow through the rear opening and attach it onto the adapter duct . Be sure that t he male end of the elbow faces down through hole in the bottom of the dryer. Secure in place with aluminum tape. Attach aluminum tape to the back of the dryer. aluminum Tape 31 Elbow 1.5 in dapter uct ckout