Downloaded from https://www.everyspec.com APPENDIX C MIL-STD-31000A Figure 38. The original feature (extrude 63) combined an extruded profile with draft angle in one feature. Figure 39. Extrude 63 was decomposed into a straight extrusion and a drafted face. The draft feature and the fillet feature at the base both failed. Upon completion of the feature translation, a skilled CATIA V5 operator must interactively repair or replace all failed features such as those shown above. Figure 40. Translated part shown in the target system. After failed features are repaired, the geometry is compared again with the original.
If it is within allowable limits, the model is checked for quality, corrected, if necessary, and released for use in the target system. 162