Specifications Factory facilities 20 Item Specifications Notes Electrical power Refer to "ML-32000-240" on page 19. Compressed air Pressure: Min. 0.6 MPa (6 bar) Required air flow capacity: 250 L/min Connector: User: Tube Φ12 mm (O.D) Machine: Fitting Φ12 mm (O.D) Required for raising/lowering the cleaning tank, ink pressure, etc. Air consumption is the amount of air in an hour. This is used to select compressors. The required air flow capacity is the flow rate which needs to be supplied from factory to the machine within a short period of time. This is used to select the main piping to the machine. Water Pressure: 0.4 Mpa (4 bar) - 0.6 MPa (6 bar) Flow rate: Max.
100 Liter/hr {6,102 in3/h} Connector: User: Horse + Fitting (R3/4) Machine: Fitting (Rc3/4) Required for belt cleaning. Wastewater Flow rate: Max. 100 Liter/hr {6,102 in3/h} Connector: User: Horse + Fitting Machine: PVC pipe nominal diameter 40A (Φ48 mm (O.D)) Required for wastewater for belt cleaning. Users are requested to dispose of wastewater according to local laws and regulations. Waste liquid Flushing plate Connector: User: Horse Φ12 mm (I.D) + Band Machine: Fitting Φ14 mm (O.D) Waste ink is discharged from the flushing plate and cleaning station, and therefore it is necessary to provide a route for waste liquid in the factory's drainage system.
Users are requested to dispose of waste ink according to local laws and regulations. Cleaning station Connector: User: Horse Φ27 to 28 mm (I.D) + Band Machine: Fitting Φ29 mm (O.D) Exhaust Flow rate: 1,600 m3/hr {98,000,000 in3/h} Connector: User: Horse Φ125 mm (I.D) + Band Machine: Pipe Φ123 mm (O.D) Required for mist exhaust in the machine. If a 1,600 m3/h exhaust system is not avail- able, please provide a mist exhaust fan. Network A communication speed of 100BASE-TX or more is recommended. Use a shielded twisted-pair cable (Category 5 or higher). Please provide a network environment to which a PC can be connected.