Note In the event of a device reload, subscription configurations must be synchronized to the start-up configuration of a device. This ensures that after the device reboots, subscription configurations remain intact on the device. When the necessary processes are up and running, the device attempts to connect to the telemetry receiver and resume normal operations. Pubd Restartability In Cisco IOS XE Cupertino 17.9.1, the pubd process is restartable on all platforms. Prior to this release, pubd was restartable only on certain platforms. On other platforms, to restart the pubd process, the whole device had to be restarted.
Pubd can be restarted by removing and re-adding the NETCONF-YANG or gNXI configuration, as applicable. Note that this will also restart the other NETCONF-YANG or gNXI processes. Sample Model-Driven Telemetry RPCs The following section provides a list of sample RPCs, and describes how to configure subscriptions. Managing Configured Subscriptions Currently, you can only use the gRPC protocol for managing configured subscriptions. Note SUMMARY STEPS 1. enable 2. configure terminal 3. telemetry ietf subscription id 4. stream yang-push 5. filter xpath path 6. update-policy { on-change | periodic } period 7. encoding encode-kvgpb 8. source-vrf vrf-id 9. source-address source-address 10.
receiver ip address ip-address receiver-port protocol protocol profile name 11. end DETAILED STEPS Procedure Model-Driven Telemetry Pubd Restartability Command or Action Purpose Step 1 enable Example: Enables privileged EXEC mode. • Enter your password if prompted. Model-Driven Telemetry 42