MultiPlus-II 2x120V 8. Appendix 8.1. A: Connection overview Page 28 Appendix A Load connection AC-OUT-2 - From left to right: N (neutral), L2 (phase 2), PE (earth/ground), L1 (phase 1) B Load connection AC -OUT-1- From left to right: N (neutral), L2 (phase 2), PE (earth/ground), L1 (phase 1) C AC input - From left to right: N (neutral), L2 (phase 2), PE (earth/ground), L1 (phase 1) D Auxiliary relay - From left to right: NO, NC, COM E Primary ground connection (PE) - M8 bolt F Trickle charge positive terminal (12 and 24V model only) G Battery positive connections - 2 x M8 bolt H Battery minus connections - 2 x M8 bolt I Power switch - To switch:
1=On, 0=Off, ||=charger only J Push button A - To perform a startup without assistants K Remote on/off connector - Short contact to switch to “on” L VE.Bus connectors - 2x RJ45: For remote control and/or parallel / three-phase operation M External current sensor To connect the current sensor, remove the wire bridge between the INT and COM terminals, connect the red sensor wire to the EXT terminal and connect the white sensor wire to the COM terminal.