Before using the appliance en disc holder is available from cus- tomer service under order number 00630760. 5. Rotate the lid clockwise until it en- gages. → Fig. 8 Markings and must match up. Before using the appliance Before using the appli- ance Fitting continuous feed shred- der onto the base unit Before using the appliance Prepare the base unit and the ac- cessories for use. 1. Place the continuous feed shred- der on drive 2 as shown. → Fig. 9 2. Push the continuous feed shredder down and rotate clockwise until it engages. → Fig. 10 The continuous feed shredder must be securely connected to the base unit. Overview of base units You can prepare your kitchen ma- chine as shown. → Fig.
3 series Assembling the continuous feed shredder Basic operation Basic operation Basic operation You can find out everything you need to know about operating your ac- cessory here. 1. Grip the disc holder level with the wings. → Fig. 4 The two plastic tips must point up. 2. Take hold of the required cutting disc by the edge and fit onto the disc holder with the side you re- quire facing up. Processing food with the con- tinuous feed shredder Note: Take note of the recommended speeds. → "Application examples", Page 21 Tip: For optimum results, process thin ingredients in bunches. ‒ Fit single-sided discs with the blades or serrations facing up.
‒ Fit reversible discs with the re- quired marking facing up. → Fig. 5 3. Insert the disc holder with the cut- ting disc into the housing. → Fig. 6 4. Place the lid on the housing. → Fig. 7 Markings and must match up. 1. Prepare your food. Cut large items of food into pieces so they fit into the filling shaft. 2. Insert the mains plug. → Fig. 11 3. Set the rotary switch to the recom- mended speed. → Fig. 12 19 A Food processor from the MUM5 series B Food processor from the MUMS2