This page This is the shows if the initial page ere is an act tive event in J/NX trouble the Control eshooter has ler connecte s started. ed to the NA A. after the NJ (6) (4) ) (5) 19 9 ５-３ A ctive Eve nts Con troller St atus Pag e (1) (2) (3) (7) No Name D escription 1 Status Shows a list of Controllers set in the NA. The set controller names are displayed in the “Controllers” Column. The status of control error is displayed in the “Controller Event Status” Column. “Normal” is displayed in green if there is no controller error, “Error” in red if there is an error, “—“ in black if the status cannot be read due to a communications error or others.
The status of user error is displayed in the “User Event Status” Column. “Normal” is displayed in green if there is no user error, “Error” in red if there is an error, “—“ in black if the status cannot be read due to a communications error or others. If you click on a Controller, the line will be selected. The operation mode, controller name, and IP address of the selected Controller are displayed in the status bar by selecting a Controller. If there are too many items in the list and not fit on the screen, you can scroll the list to view the non-displayed items.To scroll the list, drag or flick the scroll bar displayed on the right side of the list or the listed page.
The polling and refreshing intervals for a controller status are 1 second or so. 2 “Show Controller Events” button This button is enabled only when a Controller is selected in the list. You can move to [Active Controller Events Page] by clicking this button. 3 “Show User Events” button This button is enabled only when a Controller is selected in the list. You can move to [Active User Events Page] by clicking this button. 4 “Event Logs” tab You can move to [Event Logs Controller Status Page] by selecting this tab page.