Setting Up the OmniBook Configuring the OmniBook To run the BIOS Setup Utility 1. Close all applications, then shut down Windows and reboot the OmniBook. If necessary, you can press CTRL+ALT+DEL to reboot. 2. During reboot, when you see “Press to enter Setup” at the bottom of the screen, press F2 to start the BIOS Setup Utility. 3. The TouchPad or mouse is not active in the BIOS Setup Utility. Press the RIGHT and LEFT arrow keys to move among menus. Press the DOWN and UP arrow keys to move among parameters in a menu. Press ENTER to change a setting. See the tables below for more information. 4.
After you select the options you want, press F10 or use the Exit menu to exit the BIOS Setup Utility. If the settings cause a conflict between devices during reboot, the system prompts you to run BIOS Setup, and the conflicting settings are marked. Main Menu Default 2-6 System Time Sets the time using 24-hour format. System Date Sets the date using mm/dd/yy format. Floppy Drive Sets the floppy drive type. Hard Disk Sets the hard disk drive type and various parameters. Quiet Boot When disabled, runs power-on self-test and shows summary during boot.
Disabled Video Display Device Sets whether the built-in and external display signals automatically switch when an external display is detected, or whether both signals are active. Pressing Fn+F5 temporarily switches between options. Auto System Memory Shows the system memory size. Extended Memory Shows the extended memory size.