Remove printer drive assembly Step 1 Remove the following assemblies: • Remove the toner cartridge. See “Toner cartridge removal and replacement” on page 96. • If installed, remove tray 3. See “Remove tray 3” on page 97. • Remove the cassette from tray 2. See “Remove the cassette from tray 2” on page 97. • Remove the DIMM cover. See “Remove DIMM cover” on page 99. • Remove the rear cover. See “Remove rear cover” on page 100. • Remove the top cover. See “Remove top cover” on page 102. • Remove the EIO card (if installed). See “Remove EIO card” on page 98. • Remove the formatter PCB. See “Remove formatter PCB” on page 112.
Step 2 Remove the five self-tapping mounting screws (callout 1) and three ground screws (callout 2). • Unplug the two ribbon cables. See “Remove ribbon cable harness” on page 132. Step 3 Tilt the printer drive assembly away from the chassis and unplug all harness connectors and the I/F ribbon cable. Step 4 Lift off the printer drive assembly. 1 2 2 1 3 Figure 107. Remove mounting and ground screws Note When replacing the printer drive assembly, feed the formatter power harness (callout 3) though the shield. 134 Chapter 6 Removal and replacement C7058-90936