Remove tray 2 pickup roller and refeeder assembly Step 1 Remove the following assemblies: • Remove the toner cartridge. See “Toner cartridge removal and replacement” on page 96. • If installed, remove tray 3. See “Remove tray 3” on page 97. • Remove the cassette from tray 2. See “Remove the cassette from tray 2” on page 97. • Remove the DIMM cover. See “Remove DIMM cover” on page 99. • Remove the rear cover. See “Remove rear cover” on page 100. • Remove the top cover. See “Remove top cover” on page 102. • Remove left cover. See “Remove left cover” on page 105. • Remove the EIO card. See “Remove EIO card” on page 98. • Remove duplexer tray. See “Remove duplexer tray” on page 120.
• Remove the formatter PCB. See “Remove formatter PCB” on page 112. • Remove the power supply. See See “Remove power supply assembly” on page 122. • Remove the printer drive assembly. See “Remove printer drive assembly” on page 134. Note The following removal is only required if the refeeder sensor lever is being removed. • Remove the registration assemble. See “Remove registration assembly” on page 158. Step 2 Rotate the gear (callout 1) to clear the solenoid arm then remove the gear and spring. Note To remove the tray 2 pickup-roller drive shaft, release the locking tab of the white bushing at the solenoid end and slide the shaft out of the roller carriage. 21 Figure 131.
Remove tray 2 pickup-roller gear and spring Note When replacing the shaft, verify the tray 2 paper-sensor lever moves freely. C7058-90936 Internal disassembly and assembly 153