SETUPS If you select “Manual”, follow the following instruction to set the IP address and DNS. Enable(Easy) EN home A “Settings” A “Advanced Setup” A “Others” A “Network Connection” A “Enable (Easy)” 4-a) IP address setting screen will appear. Enter IP address, subnet mask and default gateway with cursor buttons and number buttons. Network settings are set to the following settings initially.
(In most cases, you can connect to the Internet without making any changes to the default settings.) - IP Address Setting Auto(DHCP) - DNS Setting Auto(DHCP) - Proxy Setting Do Not Use - Connection Speed Auto - BD-Live Setting Allow If you want to set the network settings back to the default settings as above (except “BD-Live Setting”), follow the procedure below. Enter the IP address number after checking the specifications of your router. If the IP address is unknown, check the IP address of other devices. (e.g. PC connected via LAN cable) and assign a different number from those of other devices. After you enter all correctly, press [OK] to go to the DNS setting screen.
Introduction Connections Basic Setup Playback Others Function Setup Other Functions 1) Follow steps 1) to 4) in “Connection Test” on page 52. 2) Use [ K / L ] to select “Enable(Easy)”, then press [OK]. The unit will start the connection test automatically and the test result will appear right after the test finishes. After the connection test finishes, press [OK] to go to network status confirmation screen. 4-b) DNS setting screen will appear. Enter primary DNS and secondary DNS with cursor buttons and number buttons. 3) Press [OK] to activate the network settings and set the network connection automatically. [ (home)] to go back to the home menu.
DNS Setting Primary DNS Note The setting of “BD-Live Setting” will not be set back to the default, even if you follow the procedure. Secondary DNS Clear OK Enter the DNS addresses provided by your Internet provider. If the DNS address is unknown, check the DNS address of other devices (e.g. PC connected via LAN cable) and assign the same DNS address. Enable(Custom) home A “Settings” A “Advanced Setup” A “Others” A “Network Connection” A “Enable (Custom)” In following cases, select “Enable(Custom)” to set each setting as necessary. 4-c) After you enter all correctly, press [OK] . Confirmation message will appear. Select “Yes” to complete the settings.
- When connection test failed with the setting of “Enable(Easy)”. - When instructed by your Internet service provider to make specific settings in accordance with your network environment. IP Address Setting / DNS Setting 1) Follow steps 1) to 4) in “Connection Test” on page 52. 5) Press [BACK U ] to go back to the previous screen, or press [ (home)] to go back to the home menu. 2) Use [ K / L ] to select “Enable(Custom)”, then press [OK]. 3) Use [ K / L ] to select “IP Address Setting”, then press [OK]. 4) Use [ K / L ] to select the desired setting, then press [OK]. “Auto(DHCP)” : If your router has DHCP server function, select “Auto(DHCP)”. “Manual” :
If your router does not have DHCP server function, select “Manual”. EN 53 IP Address Setting IP Address Subnet Mask Default Gateway Clear OK IP Address xxx.xxx.xxx.xxx Subnet Mask xxx.xxx.xxx.xxx Default Gateway xxx.xxx.xxx.xxx Primary DNS xxx.xxx.xxx.xxx Secondary DNS xxx.xxx.xxx.xxx Is Setting OK? Yes No