Phoenix Model 8612 I NSTALLATION I N A M OBILE H OME Follow these special requirements for installing your stove in a mobile home. Chimney Cap Install the stove in accordance with 24 CFR, Part 3280 (HUD) Chimney Section Storm Collar Permanently attach the stove to your mobile home’s floor. Use the 1/4" holes or notches in each leg base to bolt down the stove. Adjustable Roof Flashing Install one of the following Dura-Vent Mobile Home Chimney & Connector Kits: 6DP-MH 6” Diameter S/N 9096N 7DP-MH 7” Diameter S/N 9196N 8DP-MH 8” Diameter S/N 9296N Support Box Each kit includes:
Starter section with built-in Stainless spark arrester cap, storm collar, Adjustable vented flashing – 0/12 – 6/12, two 24” Dura/Plus* chimney pipes, 24” support box with built-in starter section and trim. * (UL or ULC approved equipment is acceptable) Stovepipe You must remove the exterior chimney sections when transporting Mobile Home. WARNING: DO NOT INSTALL IN A ROOM USED FOR SLEEPING. CAUTION: MAINTAIN THE STRUCTURAL INTEGRITY OF THE MOBILE HOME WALLS, FLOOR, CEILING, AND ROOF WHILE YOUR STOVE IS INSTALLED, AND IN USE. WARNING: DISCONNECT CHIMNEY BEFORE TRANSPORTING MOBILE HOME! Typical Mobile Home Installation. Chimney is supported by Ceiling.
Hearthstone Quality Home Heating Products, Inc ® www.hearthstonestoves.com 17