BMW — Inspection III

Changing oil in rear wheel drive • Pump out oil by compressing forks several times. • Screw in oil filler plugs. • Lift vehicle with lifting gear, BMW No. 00 1 510 , until the front wheel can move freely. L Note: The load on the front wheel must be relieved to en- sure as much air as possible flows in before the fixed tubes are closed off with the filler plugs so as to provide additional damping. Inspections I, III, IV • Fill with specified quantity of oil. • Close off fixed tubes. Quantities: Oil capacity, left.................................... 0.35 - 0.01 l ............................................(0.616 -0.0176 Imp.pt) Oil capacity, right.................................

0.40 – 0.01 l ...........................................(0.704 - 0.0176 Imp.pt) See service data for oil grades................Page 00.3 • Drain off oil with drive at operating temperature. • Oil drain plug (1) • Oil filler plug (2) X Tightening torque: Oil filler plugs ............................................... 20 Nm L Note: Fill oil only up to the bottom-most thread turn of the filler hole. Renewing intake air cleaner Inspection III Oil content: Initial filling ................................ 0.25 l (0.44 Imp.pt) Oil changes ............................. 0.35 l (0.616 Imp.pt) See service data for oil grades ............... Page 00.3 • Detach battery panel on right.

• Remove right knee pad. • Detach right side section of fairing. • [LT] Take off intake air pipe. X Tightening torques: Oil filler plug ................................................ 23 Nm Oil drain plug................................................ 23 Nm Changing oil in telescopic fork 1 Inspection I, III, IV • Support motorcycle on stand. • Unscrew oil filler plugs. LT000060 • Release clips (1) at front and rear. • Slightly raise casing cover, lift out air cleaner. • Install in the reverse order of removal. L Note: Note installation position of air cleaner. Lettering at rear, arrow marking “TOP-OBEN”. 1 LT000050 • Release left and right oil drain plug (1). 00.12 2 1 LT0 LT0 00040